Add multiple slave selects and Data/Command signal for SPI analyzer At the moment there is only one Enable signal for SPI. I would like to see at least 3 enable signals in case multiple sensors and devices are connected to one SPI channel. Opti...

Connect the start/stop recording to the capslock (numlock or scroll lock). This will permit capture without having to point the mouse on a screen, and in fact doesn't require to view the screen at all. A finger can be kept on the button to st...

Several signals I am analyzing require a count of rising or falling edges. Having a simple "Counter" protocol analyzer would be very helpful.

When will this finally come? It was already promised in the Q&A video from 18 oktober 2013(!), and I quote: "MIDI, actually, should be out in a WEEK." http://www.youtube.com/watch?feature=player_detailpage&v=V2-VutBvlMg#t=859 That week i...

I would love to see an analyzer for MIDI, I am working on a PIC project and am trying to get a program to output MIDI data. An analyzer which shows if I am sending what I think I am would be great. Since MIDI and DMX are VERY close I don't think...

For example, if you have three chip selects on an SPI bus you could look at the data for each chip select instead of having to reconfigure the analyzer for each one.

I have captures of around 3GB, and I'm trying to analyze 3 separate SPI bit-streams in the capture. Unfortunately the UI freezes for extended periods of time while trying to decode all the data. Instead of performing the protocol analysis on the ...

Unless I've not discovered this feature in the current software, I would like to be able to output the analyzer's conversion output to a csv file to save message data.

For the decode protocol, the source column just shows "Async Serial" and interlieaves all sources. So for looking at two Async Serials, Tx and Rx there is no differentiation/ It would be valuable for reading it to show/add the custom title of t...

The Start button initiates a capture, but after you click it, nothing changes - you just get a modal box indicating trace progress with a Stop button inside. Why not make the Start Button change to a Stop button (and turn red) when capturing. I...